Like any skill someone people have a knack and or learn it easily. I am very object orientated so tinkercad clicked fast for me. I did have some basic ...
Several useful rocketry calculators. https://rocketrycalculator.com/ ------------------------------ Brian Schenkenberger President of CENJARS --- ...
Chris and Paul, Thanks very much for the explanation and the warning. I have burned my hand with this stuff before, and, yes, it hurts like the devil! ...
I probably should do a proper introduction post here but I wanted to say it's good to see another one who really likes the Nova Payloader. Attached pictures: ...
When I model a rocket there is a few stages. once I have selected a victum the first stage is "rough modelling" you saw that yesterday. Well after some ...
I am curious. Modified or just unknown? an ender 3 v2 should have a 25cm ceiling not 18cm ??? your build volume should be 220x220x250 ALSO there are very ...
I wet the decal face down in warm water and make sure the paper backing is wet too. Then I sit them on the counter face up for a few minutes to let the ...
Hi Jeff, Afraid I never got your email. I went back and looked in the spam folder and no luck there (although if you sent more than 30-days ago it may ...
Almost done with my D upscale (no it didn't take THAT long, but I've been busy and out of town...). I'm gonna start with different-length tethers to ...
I'm not worried about my L1. I'm confident the rocket will work and I'm flying it this saturday the 25th. I was asking what material (other than fiberglass) ...
Found the plans online, including the fin pattern. Fun build. ------------------------------ Doug Kreusch doug-k@comcast.net ---------------------- ...
5 hours later with my obsession and I am close :-) ------------------------------ CHRIS TAYLOR NAR@NERYS.COM ------------------------------
Aloha All! Update and close-out. I shared all this advice with my boy, who decided he did not like any of it. Mosquito went up and presumably came ...
Here is part 2 sitting on top of part 1. part 3 the nose cone is printing now. then coupler sleeve and mmt. ------------------------------ CHRIS TAYLOR ...
Wow! Very impressive. Thanks for your reply. I've sent you a private email with a few more comments and requests. ------------------------------ Glen ...
National Association of Rocketry2275 Geode StreetMarion, Iowa 52302(319) 373-8910
E-mail: nar-hq@nar.orgWeb: www.nar.org
Renew Your Membership TodayUpdate My ProfileUpdate My Address
About UsTerms of Use